The automatic electronic diagnostic device AMSAT-HC® follows the principle of "segmentary diagnostics", meaning that the body is investigated using an electrical subdivision analyzing 22 different segments. A minimal current flows between six electrodes that are placed on the forehead, the hands, and the feet. By measuring the reduction of the amperage in each of the 22 channels a diagnosis can be made as to the function of the organs and structures included.

The measurements are compared with individual normal values taken from a huge data bank. Therefore all organs and systems can be scrutinized and findings of hyper, normal or hypo functions can be assessed. The results can be shown as numbers, frameworks, histograms, and anatomical "phantom" images.

A short examination takes 17 seconds and gives a complete review of the patient’s condition. So this method is ideally suitable for an instant diagnosis when used as a basic medical check-up or by ambulatory services. Further tests can be made and the results compared as to the use of medication or for follow-up studies.

AMSAT-HC® results have proved to be extremely accurate (usual variance only +/- 2 %) after undergoing a series of stringent tests. The procedure can be delegated and demands not more than a few minutes of the physician's time. As a biophysical method it has clear advantages over biochemical investigations that are only able to show a small part of the body's functions. The device has a great future in diagnostics and therapy control and could possibly be used as a standard medical procedure.

What is the function of AMSAT- HC®?

It can:

• Give a full organ analysis within 17 seconds.
• Describe the organs and structures directly and anatomically, without translation... problems using graphs and organ symbol charts.
• Quantify and list the functional aberrations (hyper- and hypo-)
• Control the personal health development over time and quantify and localize it.
• Configure an individual data bank and use it for treatment purposes.

How?

• AMSAT-HC® is rather simple electro-technical method: it primarily measures the volume resistances in the body and secondly the plain skin resistances.
• The paradigm of AMSAT-HC® is: the functional abilities are directly proportional to the
  .conductance and indirectly proportional to the resistance.
• The current flows along the route with the lowest resistance and the shortest distance.
• The examination and the evaluation of the results are based on huge data banks.
• Each result is individual, taking into consideration age, sex, height, weight, time, and
  ... room temperature.

What are the benefits of AMSAT- HC®? Screening and general analysis within a short time period. Recognition of latent weak points by inducing and demasking. High tolerances and low variances, stress free analysis. High sensitivity on the psychological level, too. Ability to perform medication tests quickly and easily.

A metaphor:

• A comparison between AMSAT-HC® and seismology: detection and localization of petrol oil under the desert.
• Technically produced seismic waves flow mainly through the interior of the earth (= organism) and partly over the surface of the earth (= skin).
• From the different wave data at several detector stations the seismologist can calculate the amount and the location of oil.
• AMSAT-HC® is working similarly, however, using electric current impulses, and looking for the organic functions.

What are the electric current characteristics?

Direct voltage of 6.7 V, amperage around 80 µA, wattage ca. 500 µW, modulation frequency 10-25 Hz, resistance between skin and the plain electrodes ca. 80,000 Ohm. So: not harmful in any way.

What are hyper- and hypo- functions?

Hyper: functional increase, high temperature, high perfusion, matrix over-acidity, hydration, lymphatic congestion, inflammation, ionic overload, state of "sol", short term stress.
Hypo: functional decrease, low temperature, low perfusion, alkaline milieu, dehydration, degeneration, deficit of ions, state of "gel", long term stress.

Procedure:

• Six plain electrodes are placed on the body, two on the forehead, two in the hands and two under the feet. Of the 30 possible cross connections (pole changes incl.) 22 are used as current flow channels.
• During a short measurement (17 seconds) each channel is checked several times to calculate: which way is the impulse altered between the emitter and the receiver.
• The interference between the channels results in a comprehensive assessment of the inner organs.
• The software compares the results of 67 organs and structures respectively with individualized normal values stored in the data bank.
• The functional state, the state of the pH values, and the "risk" of future medical problems are the criteria and are illustrated.

Results can be expressed in the following formats:

1. Column graphs
   a) holistic functional state values within one measurement
   b) organs and systems colloidal situations
   c) values of the "risks" can be assessed
2. Circle diagrams of
   a) all 22 channels within the body
   b) all organs and systems
   c) two desired measurements compared
3. Anatomical images = "Phantoms"
   a) color coded hyper-/hypo-functions of all organs/structures
   b) pH distributions
   c) risk estimations
   d) comparison of measurements

Ease of use

Each measurement can be performed by a simple mouse click. 20 measurements take ca. 7 minutes. Remedies are tested for their efficiency being placed in the breastbone pit (virtual testing). The effects of each kind of therapy are also tested.

The evaluation by the therapist takes about 5 minutes. All pictures on the desktop can be marked with a doctor's comment and printed using "Microsoft Word".

Certification:

ISO 13485 Medical. CE-certification of the EU. (Notified body). Medicine product class IIa. US FDA pending

Top of page | Instrumentation Page